Dan,
I've increased the debug in this daemons (and others) but I didn't saw
anything unusual. This debug level should print the content of the chirp
request?
Thanks,
Gabriel
On Fri, 2010-04-09 at 10:03 -0500, Dan Bradley wrote:
Adding D_SYSCALLS to SHADOW_DEBUG and STARTER_DEBUG may help. Then look
in the shadow and starter logs to see where the extra junk first shows up.
--Dan
Gabriel A. von Winckler wrote:
Hi,
I found a very strange situation using condor_chirp in a job running in
the parallel universe.
My MPI wrapper script execute the follow command:
$(condor_config_val libexec)/condor_chirp get_job_attr AllRemoteHosts
The result is the expected (the same from condor_q -l) except on an
execution with 2 nodes.
Here is the output:
"slot4@xxxxxxxxxxxxx,slot8@xxxxxxxxxxxxx"nfig
Note the extra "nfig".
Is this expected somehow?
How should I debug this?
I'm using condor 7.4.1.
Thanks,
Gabriel
_______________________________________________
Condor-users mailing list
To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
subject: Unsubscribe
You can also unsubscribe by visiting
https://lists.cs.wisc.edu/mailman/listinfo/condor-users
The archives can be found at:
https://lists.cs.wisc.edu/archive/condor-users/
_______________________________________________
Condor-users mailing list
To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
subject: Unsubscribe
You can also unsubscribe by visiting
https://lists.cs.wisc.edu/mailman/listinfo/condor-users
The archives can be found at:
https://lists.cs.wisc.edu/archive/condor-users/
_______________________________________________
Condor-users mailing list
To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
subject: Unsubscribe
You can also unsubscribe by visiting
https://lists.cs.wisc.edu/mailman/listinfo/condor-users
The archives can be found at:
https://lists.cs.wisc.edu/archive/condor-users/