Re: [Condor-users] Erro in condor_chirp

["Gabriel A. von Winckler" <winckler@xxxxxxxxxxxx>]

Dan,

I've increased the debug in this daemons (and others) but I didn't saw
anything unusual. This debug level should print the content of the chirp
request?

Thanks,

Gabriel

On Fri, 2010-04-09 at 10:03 -0500, Dan Bradley wrote:
> Adding D_SYSCALLS to SHADOW_DEBUG and STARTER_DEBUG may help.  Then look 
> in the shadow and starter logs to see where the extra junk first shows up.
> 
> --Dan
> 
> Gabriel A. von Winckler wrote:
> > Hi,
> >
> > I found a very strange situation using condor_chirp in a job running in
> > the parallel universe.
> >
> > My MPI wrapper script execute the follow command:
> >
> > $(condor_config_val libexec)/condor_chirp get_job_attr AllRemoteHosts
> >
> > The result is the expected (the same from condor_q -l) except on an
> > execution with 2 nodes.
> >
> > Here is the output:
> >
> > "slot4@xxxxxxxxxxxxx,slot8@xxxxxxxxxxxxx"nfig
> >
> > Note the extra "nfig".
> >
> > Is this expected somehow?
> > How should I debug this?
> >
> > I'm using condor 7.4.1.
> >
> > Thanks,
> > Gabriel
> >
> > _______________________________________________
> > Condor-users mailing list
> > To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
> > subject: Unsubscribe
> > You can also unsubscribe by visiting
> > https://lists.cs.wisc.edu/mailman/listinfo/condor-users
> >
> > The archives can be found at:
> > https://lists.cs.wisc.edu/archive/condor-users/
> >   
> _______________________________________________
> Condor-users mailing list
> To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
> subject: Unsubscribe
> You can also unsubscribe by visiting
> https://lists.cs.wisc.edu/mailman/listinfo/condor-users
> 
> The archives can be found at:
> https://lists.cs.wisc.edu/archive/condor-users/