Thanks for the reply.. It is already enabled..The steps i am following are
read-configuration file.check
instruction fetch trace instruction fetch mode
istc-disable
dstc-disable
cpu-switch-time 1
magic-break-enable
load-module ruby
ruby0.int
ruby0.load-caches
roby0.clear-stats
c
ruby0.dump-stats
> set magic-break-enable before load ruby module.
>  ------------------
>    Fu Guitao
>
>
>
>
>
>
>   ------------------ Original ------------------
>   From:  "Nagaraju"<n.polavarapu@xxxxxxxxxxxxx>;
>  Date:  Thu, Nov 17, 2011 11:07 PM
>  To:  "gems-users@xxxxxxxxxxx"<gems-users@xxxxxxxxxxx>;
>
>  Subject:  [Gems-users] SPLASH2 benchmark results
>
>
> Hi,
>
> I have run splash2(water/ocean/barnes) and dump the stats but before I
> dump the stats, I am doing 'c' in simics
> ------------------------------------------
> Example:
>
> 1.  ruby0.load-caches <path to the cache file>{What path to give?]
> 2.  ruby0.clear-stats
> 3.  c
> 4.  When the parallel section ends the simulation will stop. Do
> 5.  ruby0.dump-stats <path of the result file /filename.txt>
> ------------------------------------------
> But in my simulation after doing 'c' the simulation is never ending and
> it
> is continuously running. Depending on the amount of time I run, I am
> getting different results. What mistake I made?
>
> Thanks in advance..
>
>
> --
> Thanks & Regards,
> P. Nagaraju,
> _______________________________________________
> Gems-users mailing list
> Gems-users@xxxxxxxxxxx
> https://lists.cs.wisc.edu/mailman/listinfo/gems-users
> Use Google to search the GEMS Users mailing list by adding
> "site:https://lists.cs.wisc.edu/archive/gems-users/" to your
> search._______________________________________________
> Gems-users mailing list
> Gems-users@xxxxxxxxxxx
> https://lists.cs.wisc.edu/mailman/listinfo/gems-users
> Use Google to search the GEMS Users mailing list by adding
> "site:https://lists.cs.wisc.edu/archive/gems-users/" to your search.
>
>
-- 
Thanks & Regards,
P. Nagaraju,
 |