Re: [Gems-users] control-c not halting simulation in Simics 3

["Berkin Ozisikyilmaz" <boz283@xxxxxxxxxxxxxxxxxxxx>]

Hi,

I have been using simics 3 with opal for a while and the control-c doesn't
work. I usually have the break calls in my compiled code to be able to stop
the simulation before the set number of instructions gets executed.

Berkin

-----Original Message-----
From: gems-users-bounces@xxxxxxxxxxx [mailto:gems-users-bounces@xxxxxxxxxxx]
On Behalf Of Philip Garcia
Sent: Wednesday, July 30, 2008 6:21 PM
To: Gems Users
Subject: [Gems-users] control-c not halting simulation in Simics 3

I have recently migrated over to using simics 3, and have noticed that  
when using opal, the simulation no longer pauses when I hit control- 
c.  Is this happening to anyone else using simics 3?  It is quite  
annoying, as I need to occasionally stop simulations to examine the  
state when something goes wrong.  However as it stands, I have to wait  
for opal to finish executing (once it finishes the set number of  
instructions it pauses as before).   Does anyone know why this  
behavior changed, or where the hooks into simics to pause the  
simulation take place?  No other modules seem to cause this behavior.   
It's also quite annoying as the only way to currently cancel a  
simulation is to use kill -9.

Phil
_______________________________________________
Gems-users mailing list
Gems-users@xxxxxxxxxxx
https://lists.cs.wisc.edu/mailman/listinfo/gems-users
Use Google to search the GEMS Users mailing list by adding
"site:https://lists.cs.wisc.edu/archive/gems-users/"; to your search.