Re: [Gems-users] why I can not get the result

["Dan Gibson" <degibson@xxxxxxxx>]

'opal0.sim-step X' runs the simulation for X instructions. You need not use 'c' at all.

2008/7/13 <llccdd1985@xxxxxxx>:

thanks,

I use your method to simulate it,But I type the command as below:

simics>opal0.sim-step 9999999999

It will spend a long time to finish it,does it tell the simics  doesn't stop  until executing  9999999999 instructions?

Is your meaning that after I use opal0.sim-step,wait it finish,then  I use  c  to start simulate?

then  I can get the result? 

 

thanks

---

渊波阔宅 湖景人生
_______________________________________________
Gems-users mailing list
Gems-users@xxxxxxxxxxx
https://lists.cs.wisc.edu/mailman/listinfo/gems-users
Use Google to search the GEMS Users mailing list by adding "site:https://lists.cs.wisc.edu/archive/gems-users/" to your search.

-- 
http://www.cs.wisc.edu/~gibson [esc]:wq!