[HTCondor-users] Windows CM not connecting to other Windows Execute nodes

["Sam.Dana@xxxxxxxxxxx" <Sam.Dana@xxxxxxxxxxx>]

I can get the single host "mini" configuration executing the "sleep"  example.
I configure the second host as an Execute only node, but I can't get it to appear in condor_status, and host2 condor_status only shows host1.
I managed to get CREDD working on host1, but I can't "push" the creds to host2 - I have gotten various errors
  Make sure you have CONFIG access to the target Master. - would that be: ALLOW_CONFIG = Administrator@* in condor_config.credd on host1?  Logged in as Administrator@my_NTDomain 
  another about ALLOW_WRITE 

I did figure out condor_token_request_auto_approve, and that seemed to get me further. At least I know the hosts are communicating as files get pushed to host2.

Does someone have something like a step-by-step walk-through for a Windows domain pool setup? 

NOTICE: This email message and all attachments transmitted with it may contain privileged and confidential information, and information that is protected by, and proprietary to, Parsons Corporation, and is intended solely for the use of the addressee for the specific purpose set forth in this communication. If the reader of this message is not the intended recipient, you are hereby notified that any reading, dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited, and you should delete this message and all copies and backups thereof. The recipient may not further distribute or use any of the information contained herein without the express written authorization of the sender. If you have received this message in error, or if you have any questions regarding the use of the proprietary information contained therein, please contact the sender of this message immediately, and the sender will provide you with further instructions.