AW: AW: [Condor-users] Processor-architecture

["Thomas Bauer" <tombauer@xxxxxxxxxxxxxxxxxxx>]

>Yup, you took the manual "SUBSYS_ATTRS" too literally.  What you really
need
>is:
>
>STARTD_EXPRS = ARCH_TYPE
>(or)
>STARTD_ATTRS = ARCH_TYPE 

Ah, ok, this makes sense ;-)

Thanks,
Thomas Bauer



-----Ursprüngliche Nachricht-----
Von: condor-users-bounces@xxxxxxxxxxx
[mailto:condor-users-bounces@xxxxxxxxxxx] Im Auftrag von Nick LeRoy
Gesendet: Dienstag, 29. Juni 2004 18:56
An: Condor-Users Mail List
Betreff: Re: AW: [Condor-users] Processor-architecture

On Tue June 29 2004 11:08 am, Thomas Bauer wrote:
> Hi,
>
> I modified my condor_config on a specific machine with the following 
> lines
>
> SUBSYS_ATTRS = ARCH_TYPE
> ARCH_TYPE = "P4"
>
> After that I made a condor_reconfig on that machine.
> But when I submit a job with requirements = ARCH_TYPE == "P4" the 
> condor_q -analyze says, that no matching machine is available.
>
> Did I get something wrong?

Yup, you took the manual "SUBSYS_ATTRS" too literally.  What you really need
is:

STARTD_EXPRS = ARCH_TYPE
(or)
STARTD_ATTRS = ARCH_TYPE

You're trying to set the expression for a particular subsystem, in this
case, the startd.

Hope this helps

-Nick


-- 
           <<< The answer is out there, Neo. >>>
 /`-_    Nicholas R. LeRoy               The Condor Project
{     }/ http://www.cs.wisc.edu/~nleroy  http://www.cs.wisc.edu/condor
 \    /  nleroy@xxxxxxxxxxx              The University of Wisconsin
 |_*_|   608-265-5761                    Department of Computer Sciences
_______________________________________________
Condor-users mailing list
Condor-users@xxxxxxxxxxx
http://lists.cs.wisc.edu/mailman/listinfo/condor-users