[Gems-users] Ruby Parameters setup problem

[Edward Lee <edwl202@xxxxxxxxx>]

Hi all,

I am having problems running RUBY on a cluster. On the home node everything seems to be running fine, but when I try to run RUBY on the compute nodes (/home is mounted on the compute nodes) I can successfully load RUBY but cannot set the parameters. Below is an example of such a case:

simics> load-module ruby
successful installation of the ruby timing model.
simics> ruby0.setparam g_NUM_PROCESSORS 16
unknown command 'ruby0.setparam'.

Any ideas what might be going wrong here?

Thanks,

Ed