Re: [Condor-users] Condor 7.4.3 - stork_server missing

[Todd Tannenbaum <tannenba@xxxxxxxxxxx>]

Steffi Gebauer-Jung wrote:
>  Hello,
>
> I'm quite new to Condor, just playing with a small Condor pool.
> This pool was set up with Condor version 7.4.2.
> Now I tried to add another node using version 7.4.3.
> The MasterLog says: "stork_server: Cannot execute".
> And actually I could not find stork_server in the downloaded tarball.
> Is it to be installed separately?

If you are not using Stork (if you are not sure if you are or not, you 
aren't using it), you should be able to fix the above problem by 
removing the word STORK from the line in your condor_config that starts 
with DAEMON_LIST, and then firing up the condor_master as usual.  Doing 
this will tell the condor_master to not bother trying to start up the 
stork_server.

As for why there is no stork_server in your tarball: it only appears on 
Linux w/ GNU LibC 2.3 (essentially, RHEL 3 and its ilk).

regards,
Todd


> Thanks for your help,
> Steffi
>
>
>
>
>
>
>
>
>
>
> _______________________________________________
> Condor-users mailing list
> To unsubscribe, send a message to condor-users-request@xxxxxxxxxxx with a
> subject: Unsubscribe
> You can also unsubscribe by visiting
> https://lists.cs.wisc.edu/mailman/listinfo/condor-users
>
> The archives can be found at:
> https://lists.cs.wisc.edu/archive/condor-users/


--
Todd Tannenbaum                       University of Wisconsin-Madison
Center for High Throughput Computing  Department of Computer Sciences
tannenba@xxxxxxxxxxx                  1210 W. Dayton St. Rm #4257
Phone: (608) 263-7132                 Madison, WI 53706-1685