Re: [Condor-users] glidein error

[anayar1@xxxxxxxxxxx]

What is the easiest way to do it, should I create a local config file with those
values and ask glidein to use it instead of creating its own? Can I insert these
values into the glidein condor_config file after the master has started on it?
Is there a way to restart the master on the globus resource w/o running glidein
again?

--Arun


Quoting Dan Bradley <dan@xxxxxxxxxxxx>:

>
> You need full inbound and outbound connectivity to the glidein daemons
> (but significant effort has gone into removing this requirement in the
> future).  If glidein is running in a private network, then you will need
> to have a range of ports opened for use by Condor and you will need to
> configure HIGHPORT and LOWPORT in the glidein condor_config file.
>
> --Dan
>
> A Nayar wrote:
>
> >Schedlog says, unable to connect to the globus resource, so that seems to be
> >the problem...
> >
> >On Thursday 09 December 2004 05:11 pm, Dan Bradley wrote:
> >
> >
> >>Places to look for possible error messages related to this problem:
> >>
> >>NegotiatorLog
> >>SchedLog
> >>StartLog (of remote execution machine)
> >>
> >>--Dan
> >>
> >>A Nayar wrote:
> >>
> >>
> >>>Hi,
> >>>
> >>> I have managed to get the globus resource to report back to the local
> >>>pool and now I see the 48 extra vms that I allocated for that resource,
> >>>now when I try to do a simple helloworld example with requirements to run
> >>>only on the globus resource the job stays in idle state
> >>>
> >>>condor_q gives the following output
> >>>
> >>>22.002:  Run analysis summary.  Of 49 machines,
> >>>     1 are rejected by your job's requirements
> >>>     0 reject your job because of their own requirements
> >>>     0 match, but are serving users with a better priority in the pool
> >>>    48 match, match, but reject the job for unknown reasons
> >>>     0 match, but will not currently preempt their existing job
> >>>     0 are available to run your job
> >>>       Last successful match: Thu Dec  9 14:47:32 2004
> >>>
> >>>Why does it match and then not run, I saw lot of posts earlier with this
> >>>same error but couldnt find a solution in those mails.
> >>>
> >>>--Arun
> >>>
> >>>
> >>_______________________________________________
> >>Condor-users mailing list
> >>Condor-users@xxxxxxxxxxx
> >>http://lists.cs.wisc.edu/mailman/listinfo/condor-users
> >>
> >>
> >
> >
> >
>
> _______________________________________________
> Condor-users mailing list
> Condor-users@xxxxxxxxxxx
> http://lists.cs.wisc.edu/mailman/listinfo/condor-users
>




----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.