[Gems-users] Result of Ruby where is L1

[tian <tian@xxxxxxxxxxxxxxxxxxxxxxx>]

Hello Everyone

I'm new to GEMS, and i got a question about the result of simulation.

The protocol that I used is “MI_example” which im pretty sure is a 
simple protocol with only one level of Cache.
But after I loaded ruby, I found there were parameters (Assoc and Num of 
sets bits ) for both L1 and L2 at default parameters.
After a simple 10000 cycle operation, the state file shows that no L1 
hit or miss. All the misses during these 10000 cycles were at L2. I’m 
confusing now… why there would be L2 during the simulation when the 
protocol does not even have it. How it works? And how can I configure it 
to have only L1. Thanks
Best Regards

G.Tian