It has been ages since I used opal, but as I recall, that is the expected behavior, strange though it is. If you want opal to step fifty MORE instructions, try opal0.sim-step 550.
Regards,
Dan
On Fri, Sep 18, 2009 at 9:22 AM, sparsh mittal ISU <sparsh@xxxxxxxxxxx> wrote:
Hello List
I an running opal and found a strange behavior which I could not understand. Once I do sim-step for X number of instructions, opal no longer steps for any Y<X, one has to run it for instructions more than X. If we run it for Y<X, it just shows the output for previously executed X instructions. Is it expected (normal) or strange? I would be grateful for your reply.
simics> opal0.sim-step 500
simulate: completed 502 instructions, cycle: 153
simics> opal0.sim-step 500
simulate: completed 502 instructions, cycle: 153
simics> opal0.sim-step 50
simulate: completed 502 instructions, cycle: 153
--
Thanks and Regards
Sparsh Mittal
_______________________________________________
Gems-users mailing list
Gems-users@xxxxxxxxxxx
https://lists.cs.wisc.edu/mailman/listinfo/gems-users
Use Google to search the GEMS Users mailing list by adding "site:https://lists.cs.wisc.edu/archive/gems-users/" to your search.
--
http://www.cs.wisc.edu/~gibson [esc]:wq!
|
![[Computer Systems Lab]](http://www.cs.wisc.edu/pics/csl_logo.gif){kind=logo}