[Gems-users] Running ruby and opal

[lya755@xxxxxxxxxxxxxxxxxxxx]

Dear list,

I have a question running GEMS module with simics (bagle). I followed the 
steps on the Quickstart page 
http://www.cs.wisc.edu/gems/doc/wiki/moin.cgi/QuickStart and have reached the 
step of start simulation. Since I am using opal together with ruby, I typed in 
command line "opal0.sim-step 10000000000". However, as far as I observe, the 
simulation doesn't seem to have started since the simics simulator console 
does not respond to any of my key stoke. Also, I found on simics command line 
a lot of this message:

patch  PC: 0x4432c4 0x409800
patch  NPC: 0x480fd4 0x409804
patch  PC: 0x465eb8 0x409800
patch  NPC: 0x480d88 0x409804
patch  PC: 0x480d94 0x409800
patch  NPC: 0x481164 0x409804
patch  PC: 0x48116c 0x409800
patch  NPC: 0x42fbb4 0x409804
patch  PC: 0x42fd64 0x409800
patch  NPC: 0x4105bc 0x409804
patch  PC: 0x53401c 0x409800
patch  NPC: 0x4d0c9c 0x409804
patch  PC: 0x4d0cbc 0x409800
patch  NPC: 0x4d2cb4 0x409804
patch  PC: 0x47a990 0x409800
patch  NPC: 0x47a9b4 0x409804
patch  PC: 0x47b028 0x409800
patch  NPC: 0x4769d4 0x409804
patch  PC: 0x408d00 0x5e5c40
patch  NPC: 0x408d04 0x5e5c44
patch  PC: 0x476a3c 0x409800
patch  NPC: 0x4105bc 0x409804
.....

Have anyone met with this kind of problem before? Please give me a hand! 
Thanks a lot!

Lei
_________________________________________________________
This message was sent through the NU ECE webmail gateway.